A Geoid is the equipotential surface of the Earth’s gravity field which best fits, in a least squares sense, global mean sea level.  The Geoid Field File enables the user to utilize a Geoid Model that is appropriate for the mapping are under consideration. With a Geoid Model attached to a Coordinate System the user can compute Geoid Separations of  the  points  in  a  project. If  Geoid  Separations  are  available  it  enables  the  user  to  switch  between  viewing  Ellipsoidal  and  Orthometric  heights.  The  relationship between  these  two  heights is given by: 

Ellipsoidal Height (h) = Orthometric Height (H) + Geoid Separation (N) 

This quick guide will go through the procedure of properly creating a Geoid Field File (.GEM) in from a Geoid Model (.byn) as found in NRCAN (Natural Resources Canada) website.     

The following is a guide that outlines the steps in using Leica Infinity Software to convert a NRCAN geoid model in .byn format into a Leica Geoid Field File (.gem) to be used in Leica Captivate/Viva/iCON data collector software and also in Leica Infinity.

NRCAN .byn to Leica Geoid Field File (.gem)

Note: Geoid Models are always an approximation of the actual Geoid.  In terms of accuracy, they may vary considerably and in particular global models should be used with care.  If the accuracy of the Geoid Model is not known it might be safer to use local control points with Orthometric heights and apply a transformation to approximate the local Geoid. 

More information can be found on the Height Reference System Modernization page: https://www.nrcan.gc.ca/height-reference-system-modernization/9054